LED Failure Modes and Methods for Analysis
LED’s open the way to new applications and markets in various different fields with a broad spectrum of requirements. Beneath other beneficial characteristics, in general, LED’s provide a high reliability, and a lifetime of more than 50;000 hours can be reached. Poor workmanship in manufacturing and unfavorable operational conditions may reduce the reliability significantly. To avoid failures or to achieve fast resolutions of existing problems a good knowledge of the failure mechanisms and ...
Read more »
LED Source Modeling Method Evaluations
Producing accurate simulations of LED based optical systems requires accurate source models. This means the source models must not only produce the correct distribution of light in a far field measurement, they must also produce the correct near field behavior since secondary LED optics are often employed in very close proximity to the LED. Accurate simulations are vital to the design process especially with lens optics commonly used on LEDs given the high cost and long lead times for lens ...
Read more »
MaxMile Technologies introduces EpiEL mapping system optimized for nitride-based LED applications
MaxMile Technologies, LLC at Lexington has recently introduced a EpiEL mapping system (EpiEL-700) which is optimized for nitride-based LED applications.
Read more »
Measurement of LEDs
Various new types of light emitting diodes (LEDs) are being developed and introduced for general illumination and other applications, and there are increasing needs for accurate measurements of various optical parameters of LEDs. Traditional standard lamps do not meet the calibration needs for LED measurements as LEDs differ substantially from traditional lamps in terms of physical sizes, flux levels, spectra, and spatial intensity distributions.
Read more »
